Need Ductwork Installation in Lithia?

Installing a new duct run in Lithia typically runs $279 to $950 per run depending on length, attic access, and whether R-6 or R-8 insulation is required under Florida Energy Code. A full ductwork system replacement runs $1,800 to $8,500 for most Lithia homes. FREE estimates on every job. We give you a flat-rate price before any work begins so you know the total before we touch anything.

Common signs in Lithia homes include uneven temperatures between rooms, higher electric bills without a usage change, visible kinked or disconnected flex duct in the attic, dusty air despite regular filter changes, and musty smells from the vents. We carry a duct blaster on every truck and can test your system’s leakage rate free while we are on site for any service call.

For attic runs in Lithia, R-6 or R-8 flex duct with a metalized outer jacket handles heat stress better than single-layer flex. For main trunk lines and plenums, 26-gauge galvanized rigid sheet metal is the most durable option. All connections get sealed with Hardcast mastic compound rather than duct tape, which fails in Tampa Bay attic heat within a few years.

Adding a single new duct run in Lithia takes 2 to 4 hours for most jobs. A full ductwork system replacement for a 1,500 to 2,000 square foot home takes 1 to 2 days depending on attic access and system configuration. We handle the permit application and county inspection, and both are included in every ductwork quote.

Yes. Any new duct installation or full system replacement in Lithia requires a permit under Florida Building Code Section 1006 and local county mechanical codes. We pull the permit and schedule the inspection on your behalf. The permit is included in your quote with no separate markup or add-on fee.

Yes. Adding supply and return air to a converted garage, bonus room, enclosed porch, or Florida room in Lithia is one of our most common ductwork calls. We use Manual D airflow calculations to size the new run correctly so the new room gets adequate airflow without starving other rooms in the house.

Florida Energy Code requires a duct leakage test on any new or replaced duct system in Lithia. The test uses a duct blaster to measure how much conditioned air escapes before reaching the rooms it serves. We perform the test as part of every ductwork installation and submit the results to the county for permit close-out. We can also test existing systems in about 30 minutes.

Flex duct in a Tampa Bay attic typically lasts 20 to 25 years if it stays intact. Rigid galvanized metal can last 30 years or more. The weakest point is always the connection seals. Duct tape dries out in Florida attic heat in as few as 3 to 5 years. We use Hardcast mastic on every connection, which outlasts the duct itself.

Yes, in most cases. Uneven temperatures are commonly caused by undersized duct runs, imbalanced airflow, or collapsed flex sections that restrict delivery. We perform a Manual D calculation before any ductwork project in Lithia to make sure each room receives the correct airflow. Properly designed ductwork is the most reliable fix for comfort problems.

We install Johns Manville or Owens Corning R-6 and R-8 flex duct, 26-gauge galvanized sheet metal for trunk lines and plenums, and Hardcast 1402 or MasterSeal mastic for all connections. We do not use duct tape on any connection. All materials meet Florida Energy Code and ACCA Manual D requirements.

A: Most Lithia homeowners see 15 to 30 percent lower cooling bills after upgrading from R-4 or R-6 flex with unsealed joints to new R-8 duct with mastic-sealed connections. The exact savings depend on your current leakage rate and how old your insulation is. We can estimate your savings during the free inspection.

A: Yes. We carry duct blaster test equipment and can measure your current leakage rate before any work. After installation, we retest to verify we hit our target of under 6 percent total leakage. Pre and post-testing is available on request at no added cost for full replacement jobs.

A: R-8 flex has a 33 percent thicker insulation layer than R-6. In a Lithia attic that hits 150 degrees, that difference means supply air arriving 3 to 5 degrees cooler at the register on a long run. Cooler supply air means shorter run cycles and lower monthly bills over a full cooling season.

A: Yes, significantly. Standard duct tape loses adhesion in 3 to 7 years in hot attic conditions. Mastic sealant stays flexible and bonded for 20-plus years under the same conditions. ENERGY STAR and Florida Building Code both require mastic or UL-181 listed tape — not commodity duct tape — for certified duct work.

A: The inspection and estimate are completely free. We come out, access the attic, photograph every run, measure insulation values, and give you a written quote for exactly what we recommend. You approve the work and the price before anything starts. No service fee, no obligation.